Operation Manual

440 ICP programming
5.13 Lateral surface contours in smart.Turn
Linear slot on lateral surface
You can find the reference diameter XR with the "select reference
plane" function (siehe Seite 425).
ICP generates:
 The LATERAL_C section code with the reference diameter
parameter. In nested contours, ICP generates only one section
code.
 A G308 with the parameters contour name and milling depth.
 A G311 with the parameters of the figure.
 A G309.
Reference data of lateral surface
ID Contour name
PT Milling depth
XR Reference diameter
Parameters of figure
Z Figure center
CYM Center of figure as linear dimension (reference: diameter XR)
CM Center of figure (angle)
A Position angle
K Length
BWidth