Operation Manual

HEIDENHAIN CNC PILOT 640 445
5.13 Lateral surface contours in smart.Turn
You can find the reference diameter XR with the "select reference
plane" function (siehe Seite 425).
ICP generates:
 The LATERAL_C section code with the reference diameter
parameter. In nested contours, ICP generates only one section
code.
 A G308 with the parameters contour name and milling depth or hole
depth (–1*BT).
 A G412 with the parameters of the pattern.
 The G function and the parameters of the figure/hole.
 A G309.
EP End angle (no entry: the pattern elements are equally divided
into 360°)
EPi Angle between two figures
H Element position
 0: Normal position—the figures are rotated about the circle
center (rotation)
 1: Original position—the position of the figures relative to
the coordinate system remains unchanged (translation)
Parameters of the selected figure/hole