Operation Manual

492 Graphic simulation
6.3 Views
Rotating the 3-D view with the menu functions
With the menu functions you rotate the graphic around the displayed
axes (see table at right). The "perspective view" soft key resets the
graphic to its initial condition.
Rotating and moving the 3-D view with the mouse
With the right mouse button pressed you can move the displayed
workpiece as required.
When you press and hold the left mouse button, you can do the
following:
 Vertical movement in the simulation window: Tilts the workpiece
forward or backward
 Horizontal movement in the simulation window: Rotates the
workpiece horizontally around its own axis
 Horizontal or vertical movement at the edge of the simulation
window (gray border): Rotates the workpiece clockwise or
counterclockwise
 Movement in any direction: Rotates the workpiece in any direction.
Soft keys for 3-D view
Displays the finished part and the
programmed workpiece blank.
Displays the finished part and the
updated workpiece blank.
Activates/Deactivates the check
mode
Displays a section view.
Selects the side view. Rotates
the side view by 90°.
Selects the perspective view.
Menu for the 3-D view
Tilt the graphic backward.
Rotate the graphic horizontally in the
indicated direction.
Rotate the graphic horizontally in the
indicated direction.
Rotate the graphic counterclockwise.
Tilt the graphic forward.
Rotate the graphic clockwise.