Operation Manual

546 Organization mode of operation
8.2 Parameters
General settings:
Parameters: System / ... Meaning
... / Definition of the units of measure valid for the display (101100)
/ ...
... / Unit of measure for display and user interface (101101)
metric Use the metric system
inch Use the inch system
... / General display settings (604800) / ...
... / Axis display (604803) Type of axis display:
 Default
 Actual value
 Nominal value
 Following error (servo lag)
 Distance-to-go
.../ File preview during program selection (604804)
TRUE File preview is displayed during program selection.
FALSE File preview is not displayed during program selection.
.../ Do not display limit switch warnings (604805)
TRUE No limit-switch warning is displayed if an axis is
positioned on the software limit switch.
FALSE The limit switch warning is displayed.
... / Settings for automatic operation (601800) / ...
.../ Service life management (601801)
ON Tool life monitoring is active
OFF Tool life monitoring is inactive
.../ Program run with the most recently selected cycle
(601809)
ON When Program Run is selected, the most recently
selected cycle remains active
OFF When Program Run is selected, the first cycle is active
.../ End mid-program startup after start block (601810)
TRUE In mid-program startup, program execution begins
with the subsequent NC block
FALSE In mid-program startup, program execution begins
with the selected NC block