Operation Manual

556 Organization mode of operation
8.2 Parameters
... / Appr./ext. contour recessing (ANKSA) (602405) Approach strategy:
 1: Move simultaneously in X and Z directions
 2: First X, then Z direction
 3: First Z, then X direction
 6: Coupled motion; X precedes Z direction
 7: Coupled motion; Z precedes X direction
... / Appr./int. contour recessing (ANKSI) (602406) Approach strategy:
 1: Move simultaneously in X and Z directions
 2: First X, then Z direction
 3: First Z, then X direction
 6: Coupled motion; X precedes Z direction
 7: Coupled motion; Z precedes X direction
... / Dep./ext. contour recessing (ABKSA) (602407) Departure strategy:
 1: Move simultaneously in X and Z directions
 2: First X, then Z direction
 3: First Z, then X direction
 6: Coupled motion; X precedes Z direction
 7: Coupled motion; Z precedes X direction
... / Dep./int. contour recessing (ABKSI) (602408) Departure strategy:
 1: Move simultaneously in X and Z directions
 2: First X, then Z direction
 3: First Z, then X direction
 6: Coupled motion; X precedes Z direction
 7: Coupled motion; Z precedes X direction
... / Recessing width divisor (SBD) (602409) Value for selecting the tool for contour recessing with
linear elements at the recess base
... / Type of oversize (KSAA) (602410) Oversize for contour recessing with contour valleys.
Standardized recesses are completed in one
machining cycle.
16 Longitudinal and transverse oversizes differ – no single
oversizes
144 Longitudinal and transverse oversizes differ – with
single oversizes
32 Equidistant oversize – no single oversizes
160 Equidistant oversize – with single oversizes
... / Equidistant or longitudinal (KSLA) (602411) Equidistant oversize or longitudinal oversize
... / Face oversize (KSPA) (602412) Transverse oversize
Parameters: Processing / ... Meaning