Operation Manual

HEIDENHAIN CNC PILOT 640 557
8.2 Parameters
... / Recessing width factor (SBF) (602413) Factor for determining the maximum tool offset
... / Recessing/finishing (602414) Sequence of finishing cuts:
 1: Part a horizontal element (previous behavior)
 2: Move through and lift-off
... / Thread cutting (602500) / ...
... / Approach/ext. – thread (ANGA) (602501) Approach strategy:
 1: Move simultaneously in X and Z directions
 2: First X, then Z direction
 3: First Z, then X direction
 6: Coupled motion; X precedes Z direction
 7: Coupled motion; Z precedes X direction
... / Approach/int. – thread (ANGI) (602502) Approach strategy:
 1: Move simultaneously in X and Z directions
 2: First X, then Z direction
 3: First Z, then X direction
 6: Coupled motion; X precedes Z direction
 7: Coupled motion; Z precedes X direction
... / Departure/ext. – thread (ABGA) (602503) Departure strategy:
 1: Move simultaneously in X and Z directions
 2: First X, then Z direction
 3: First Z, then X direction
 6: Coupled motion; X precedes Z direction
 7: Coupled motion; Z precedes X direction
... / Departure/int. – thread (ABGI) (602504) Departure strategy:
 1: Move simultaneously in X and Z directions
 2: First X, then Z direction
 3: First Z, then X direction
 6: Coupled motion; X precedes Z direction
 7: Coupled motion; Z precedes X direction
... / Thread starting length (GAL) [mm] (602505) Default value for "run-in length B"
... / Thread run-out length (GUL) [mm] (602506) Default value for "overrun length P"
... / Measuring (602600) / ...
... / Measuring loop counter (MC) (602602) Definition of the measurement/loop intervals.
... / Measuring path length in Z (MLZ) (602603) Length of departure path in Z
... / Measuring path length in X (MLX) (602604) Length of departure path in X
Parameters: Processing / ... Meaning