Operation Manual

HEIDENHAIN CNC PILOT 640 591
8.3 Transfer
USB connection
Select the Organization mode and plug the USB storage device in at
the USB port on the CNC PILOT.
Press the Transfer soft key (login required).
Press the Connections soft key.
Press the USB soft key.
The CNC PILOT opens the USB dialog box. This dialog box is for the
settings for the connection target.
Use the soft keys to disconnect and reconnect USB
storage devices.
Soft keys for USB connection
Creates a folder of the specified name
on the USB storage device.
Disconnects the USB storage device
and prepares the device for removal.
Allows access to files that have not
been properly saved in a project
folder.
Selects the project folder highlighted
previously using the arrow keys.
Returns to the Transfer soft-key
menu.
In principle, it should be possible to connect most USB
devices to the control. It may happen that a USB device is
not identified correctly by the control, for example when
the cable between the control panel and the main
computer is very long. In such cases, use another USB
device.