Operation Manual

HEIDENHAIN CNC PILOT 640 605

8.4 Service pack

If changes or additional features are required in the control software,

your machine tool builder will provide you with a service pack. The

service pack is usually installed with the aid of a USB memory stick

(1 GB or larger). The software required for the service pack is

compressed in the setup.zip file. This file is saved on the USB stick.

Installing a service pack

The control has to be shut-down during the installation of the service

pack. So end any NC program editing, etc. before you begin

installation.

Connect a USB stick and switch to the Organization mode of

operation.

Press the soft key and enter the code number

231019.

Press the soft key. (If the soft key is not visible,

switch the soft-key menu.)

Press the soft key.

Press the Path soft key to select the directory in the

left window.

Press the Files soft key to select the file in the right

window.

Place the cursor on the "setup.zip" file and press the

SELECT soft key.

HEIDENHAIN recommends backing up your data before

installing the service pack (siehe Seite 599).