Operation Manual

622 Tables and overviews
9.3 Technical information
DINplus programming  Programming in DIN 66025 format
 Extended command format (IF... THEN ... ELSE...)
 Simple geometry programming (calculation of missing data)
 Powerful fixed cycles for area clearance, recessing, recess turning
and thread machining
 Powerful fixed cycles for drilling and milling with the C axis (optional)
 Powerful fixed cycles for drilling and milling with the Y axis (optional)
 Subprograms
 Programming with variables
 Contour description with ICP (optional)
 Program verification graphics for workpiece blank and finished part
 Turret assignment and other setup information in the DINplus
program
 Conversion of smart.Turn units into DINplus command sequences
(optional)
 Parallel programming
 Parallel simulation
Test run graphics  Graphic simulation of sequence of Teach-in cycle, Teach-in,
smart.Turn or DINplus programs
 Display of the tool paths as pencil-trace or cutting-path graphics,
special identification of the rapid traverse paths
 Machining simulation (2-D material-removal graphic)
 Display of programmed contours
 Side or face view, or 2-D view of cylindrical surface for verification of
C axis machining
 View of face (XY plane) and YZ plane for verification of Y-axis
machining
 Shifting and magnifying functions
 3-D graphics for display of workpiece blank and finished part as solid-
model view
Machining time analysis  Calculation of machining times and idle times
 Consideration of switching commands triggered by the CNC
 Representation of time per individual cycle or per tool change
TURN PLUS  Automatic generation of smart.Turn programs
 Automatic cutting limitation through the definition of chucking
equipment
 Automatic tool selection and turret assignment
User functions