Operation Manual

HEIDENHAIN CNC PILOT 640 631
9.4 Compatibility in DIN programs
G commands for C-axis contours
Overlapping contours G308-Geo Start of pocket/island þ
G309-Geo End of pocket/island þ
Front and rear face contours G100-Geo Starting point of face contour þ
G101-Geo Line segment on front face þ
G102-Geo Circular arc on front face þ
G103-Geo Circular arc on front face þ
G300-Geo Bore hole on front face þ
G301-Geo Linear slot on front face þ
G302-Geo Circular slot on front face þ
G303-Geo Circular slot on front face þ
G304-Geo Full circle on front face þ
G305-Geo Rectangle on front face þ
G307-Geo Eccentric polygon on front face þ
G401-Geo Linear pattern on front face þ
G402-Geo Circular pattern on front face þ
Lateral surface contours G110-Geo Starting point of lateral surface contour þ
G111-Geo Line segment on lateral surface þ
G112-Geo Circular arc on lateral surface þ
G113-Geo Circular arc on lateral surface þ
G310-Geo Bore hole on lateral surface þ
G311-Geo Linear slot on lateral surface þ
G312-Geo Circular slot on lateral surface þ
G313-Geo Circular slot on lateral surface þ
G314-Geo Full circle on lateral surface þ
G315-Geo Rectangle on lateral surface þ
G317-Geo Eccentric polygon on lateral surface þ
G411-Geo Linear pattern on lateral surface þ
G412-Geo Circular pattern on lateral surface þ