Operation Manual

64 Basics of operation
2.6 The error messages
Clearing errors
Clearing errors outside of the error window:
 Open the error window.
 To clear the error/message in the header: Press the
CE key.
Clearing more than one error:
 Open the error window.
 To delete an individual error: Position the cursor on the
error message and press the soft key.
 To delete all errors: Press the Delete All soft key.
Error log file
The CNC PILOT stores errors and important events (e.g. system
startup) in an error log file. The capacity of the error log file is limited.
If the log file is full, it switches to the next one, etc. If the last log file
is full, the first one is overwritten by a new one, etc. If necessary,
switch the log file to see the history. 5 log files are available.
 Open the error window.
 Press the Log file soft key.
 Open the log file.
 Select previous log file, if needed.
 Select current log file, if needed.
The oldest entry is at the beginning of the log file, and the most recent
entry is at the end.
In some operating modes (such as the Editing mode), the
CE key cannot be used to clear the error, since the key is
reserved for other functions.
If the cause of the error has not been removed, the error
message cannot be deleted. In this case, the error
message remains in the window.