Manual

4
Delay
This setting changes the cyclic gyro delays. 50% has been found to be the ideal
setting and no adjustment is necessary.
Elevator Gain
The Elevator Gain is used to adjust the amount of correction that the TAGS
applies to the Pitch Axis during unintended movements. Finding the ideal gain
setting will take some experimentation. If the Pitch Axis is slowly drifting then
raise the gain and test fl y the model. If the Pitch Axis is quickly oscillating (also
known as wagging), then lower the gain and test fl y the model. Turning the
adjustment clockwise increases the gain and turning the adjustment counter-
clockwise decreases the gain.
Aileron Gain
The Aileron Gain is used to adjust the amount of correction that the TAGS
applies to the roll axis during unintended movements. Finding the ideal gain
setting will take some experimentation. If the roll axis is slowly drifting, then
raise the gain and test fl y the model. If the roll axis is quickly oscillating (also
known as wagging), then lower the gain and test fl y the model. Turning the
adjustment clockwise increases the gain and turning the adjustment counter-
clockwise decreases the gain.
PIT REV.
This setting is not used on the Novus 125 CP and must be left on the
normal setting.
On – Off TAGS
Enable TAGS - On
Disable TAGS - Off
™