User Manual

ManualsBrandsHeli-Max ManualsAir equipmentHMXG8015

Contents

(1) HMXM3005 Brushless ESC Novus FP/CP

(1) HMXG8013 Brushless Motor Novus FP/CP

Tools Required (Not Included)

(1) DTXR0180 DuraTrax

Ultimate Phillips Screwdriver 2.0mm

Heli-Max

™

Flight Battery

Heli-Max

™

Brushless

ESC

For Novus

™

Heli-Max

™

Brushless

Motor

For Novus

™

kV 11,000

MOTOR

BATTERY

ESC

Made in China

Flight Battery

Brushless

ESC

Brushless

Motor

DO NOT USE!

This connector is no longer

used. The flight battery will

plug into the ESC after the

brushless conversion has

been installed.

Receiver

(Included with

Helipcopter)

ESC

AIL

PIT

RUD

ELE

TAIL

MOTOR

MAIN

MOTOR

Novus

™

Brushless

Upgrade

www.helimax-rc.com

Summary of content (4 pages)

PAGE 1
Heli-Max™ Flight Battery AIL PIT RUD ELE (Included with Helipcopter) MAIN MOTOR Receiver ESC TAIL MOTOR Novus™ CP Brushless Upgrade Flight Battery DO NOT USE! This connector is no longer used. The flight battery will plug into the ESC after the brushless conversion has been installed.
PAGE 2
INTRODUCTION Thank you for purchasing the Novus Brushless Conversion. The brushless motor will provide greater power and longer flight times in comparison to the stock brushed motor. INSTALLATION ❏ Disconnect the main drive motor from the E-Board and remove the motor from the helicopter. Install the brushless main drive motor with the wire harness facing forward as shown. Ensure that the gear mesh is set correctly.
PAGE 3
❏ Place a piece of double-sided tape on the back side of the ESC (Electronic Speed Control). Mount the ESC onto the E-Board as shown in the picture. Route the ESC lead to the E-Board and plug it into the port labeled ESC on the E-Board. It is best to route the wires as shown above and place the old E-Board power connector on top of the E-Board to avoid accidental use. Route the ESC power lead out the bottom of the helicopter as shown (the power connector on the E-Board is no longer used).