Manual

559-734-7451 800-367-5480 FAX [phone]
5. Place heat shield on top of air spring and insert
air spring through holes in both frame brackets.
Attach using flange head nuts. Driver side shown
uses heat shield to prevent emergency brake cable
from rubbing on air spring. Align passenger side
heat shield to prevent heat from exhaust pipe from
damaging air spring. Tighten nuts to 20 ft-lb. Af-
ter tightening air spring nuts, tighten 3/4” bolt to
100-125 ft-lb. If bolt is used by fifth wheel hitch
mounting brackets, tighten bolt to hitch manufac-
turer’s specifications.
5
7
6. Insert axle bracket between air
spring and axle The short bracket is
used on driver’s side and the long
bracket is used on the passenger side.
Attach air spring to bracket using 3/8”
x 1” bolt and tighten to 20 ft-lb. In-
sert legs of U-bolt through holes in
bracket. It is preferred to use the up-
per holes, but if U-bolt cannot be in-
stalled in upper holes, use the lower
holes as shown. Attach U-bolt using
3/8” flanged lock nuts and tighten un-
til bracket flexes slightly.
6
7. Insert carriage bolts into axle bracket as
shown and attach saddle using flat washers
and flanged lock nuts as shown. Reposition
brake line as required to prevent brake line
from contacting carriage bolt. Tighten to 25
ft-lb.
7
6107 ( R-6107) 11/22/06
Emergency Brake Cable