User Manual

LP TANK RESTRAINT

If you purchased a Hestan Grill with Side Burner on a cart, be sure to restrain the LP cylinder by

securing it with the retention bolt on the slide-out tray as shown below. It is important the tank

does not fall over or stretch the hose which could cause a gas leak.

LEAK TESTING

GENERAL

Although all gas connections on your Hestan side burner are leak tested at the factory prior

to shipment, a complete gas tightness check must be performed at the installation site due to

possible movement in shipment, or excessive pressure unknowingly being applied to parts of the

unit. Periodically check the whole system for leaks, or immediately check if the smell of gas is

detected.

BEFORE TESTING

• Do not smoke while leak testing.

• Never leak test with an open flame.

• Make a soap solution of one part liquid detergent and one part water for leak testing

purposes.

• Apply the solution to the gas fittings by using a spray bottle or a brush.

• For LP units, always check with a full LP cylinder.

GAS CONNECTIONS

(continued)