Instructions/Assembly Guide

7
hestanoutdoor.com
HESTAN RESIDENTIAL INSTALLATION MANUAL FOR BEER DISPENSING EQUIPMENT
Locate the beer faucet(s) and install onto the dispensing
head shanks. Tighten with supplied spanner wrench.
Install black handle(s) onto faucet(s).
12.
On the right rear sidewall there is a double column of
screws. Remove the left screw. Locate the safety chain
and a #10 x 1/2” sheet metal screw from the parts bag.
Insert the screw through the closed end link of the chain
and tighten in the vacant screw hole. The chain can now
be used to secure the tank with “S” hook, preventing
damage to the regulator.
prior to use. Turn the adjusting knob on the regulator
counter-clockwise until the secondary gauge (top)
reads zero. Make sure that the valve at the bottom of
the regulator where the red hose is connected is in
pressure gauge, turn the regulator adjusting
knob clockwise until the p
ressure is at 15 psi.
IMPORTANT: All pressure adjustments MUST be made
10.
11.
CO2 tanks are shipped empty and must be filled
the off position as shown. Watching the secondary
Adjustments can later be made based on flow rates.
when the shut-off valve is in the OFF position!