Instructions/Assembly Guide

HESTAN RESIDENTIAL INSTALLATION MANUAL FOR BEER DISPENSING EQUIPMENT
6
hestanoutdoor.com
If installing a two faucet system, a CO2 manifold will
need to be installed. Locate the red CO2 lines, CO2
manifold and a #10 x 1/2” sheet metal screw. Slide
manifold and clamp. On the left rear side wall of the
beer compartment there is a double row of screws
which run vertically. Remove one of the two top screws
and discard. Insert the sheet metal screw through the
manifold and into the hole vacated previously.
On a single beer system, locate the red CO2 hose.
assembly and clamp. On systems with two beers, locate
regulator assembly and clamp. For detailed information
on connecting the regulator to the CO2 cylinder, see
page 8.
7.
8.
and clamp. Locate one of the black beer lines and slide
Repeat for additional couplers.
9.
one end of each hose onto the barbed fittings on the
Slide one end onto the barbed fitting of the regulator
the CO2 line that comes off the backside of the manifold
assembly. Slide the hose onto the barbed fitting of the
Locate the low profile coupler(s). Slide one of the
red CO2 lines onto the larger barbed fitting of coupler
onto the smaller barbed fitting of the coupler and clamp.