Instructions/Assembly Guide

HESTAN RESIDENTIAL INSTALLATION MANUAL FOR BEER DISPENSING EQUIPMENT
8
hestanoutdoor.com
Before tapping, make sure the beer faucet is closed. To
tap a keg, insert the coupler into the neck of the barrel.
Turn the coupler clockwise until it stops (about an 1/8
turn), then push down on the top of the coupler and
again turn clockwise until it stops. Your barrel is now
tapped. Open the CO2 valve on the regulator as well as
the valve on the manifold if used.
13.
CONNECTING THE REGULATOR TO THE CO2 CYLINDER
1.
not remove the carbonic washer.
2. Screw regulator onto gas cylinder valve. Tighten with
valve on the regulator is in the OFF (horizontal) position.
3. Place screw clamp over the end of red line and push onto
regulator tail piece. Tighten clamp with a screwdriver.
4. Turn regulator adjusting screw counterclockwise until
it turns freely.
5. Turn hand valve counter-clockwise on the CO2 cylinder
to the fully open position.
6. Turn regulator adjusting screw clockwise until desired
pressure is reached (approximately 12-15 lbs.) Tighten
stop nut on adjusting screw.
7. Open shut-out valve on bottom of regulator.
8. Dilute a small amount of liquid dishwashing soap and
rub the soapy mixture around connections. If bubbles
appear, tighten connection.
Remove the blue plug from the regulator fitting, but do
wrench until vertically straight. Be sure that the shut-off