Use and Care Manual

Table Of Contents

INSTALLATIONINSTALLATION

Make sure installation of this refrigeration appliance is performed correctly by a qualified

installer using the instructions in the Installation Manual provided with the appliance.

Always connect the water before the power.

CONNECTION TO THE WATER SYSTEMCONNECTION TO THE WATER SYSTEM

The models provided with Ice Maker require a

connection to the domestic water supply system. This

can be executed through the 1/4” water line (copper or

polyethylene) to the house water supply.

The system pressure must be between from 8 psi to 75

psi (between 0.5 Bar and 5 Bar). Different pressures

can cause malfunctions or leaks in the water system.

The appliance should be supplied only with drinkable water.

Use only the new adapter which is supplied with the appliance. The solenoid connection

on the rear of the appliance looks like 3/4” diameter but is metric threaded. A standard

garden hose threaded connector such as a braided stainless hose found at typical

hardware stores will strip or damage the solenoid threads. Use only the supplied 1/4”

quick connect elbow adapter for connecting a 1/4” copper or polyethylene source water

line to the appliance.

CONNECTION TO THE ELECTRICAL POWER SUPPLYCONNECTION TO THE ELECTRICAL POWER SUPPLY

The appliance operates at 115 VAC, 60 Hz and is equipped with

a power supply cord with a 3-prong grounded plug, which must

be connected to a corresponding 3-prong (15 Amp) grounding-

type wall receptacle.

A circuit breaker or suitable fuse should be easily accessible

so that it can be easily switched off before performing any

installation or maintenance.

• DO NOT ground to a gas pipe.

• DO NOT have a fuse in the NEUTRAL or GROUNDING

circuit. A fuse in the NEUTRAL or GROUNDING circuit

could result in an electrical shock.

• Do not use extension cords and/or multiple adapters for the power supply

connection.

SAFETY PRECAUTIONS - BEFORE YOU BEGIN

(CONT.)