Installation Manual
Table Of Contents
- SAFETY PRECAUTIONS - BEFORE YOU BEGIN
- MODEL NUMBERS
- RATING LABEL
- REGULATORY / CODE REQUIREMENTS
- IMPORTANT CHILD SAFETY
- LOCATION AND PREPARATION
- CONNECTIONS
- Overlay Panels
- FINAL INSTALLATION
- TESTING AND INITIAL START UP
- PARTS AND SERVICE
- PRÉCAUTIONS DE SÉCURITÉ - AVANT DE COMMENCER
- numéros de modèle
- PLAQUE SIGNALÉTIQUE
- EXIGENCES RÉGLEMENTAIRES / CODE
- POUR LA SÉCURITÉ DES ENFANTS
- Lieu et préparation
- CONNECTER
- PRÉPARATION DES PANNEAUX DÉCORATIFS
- Installation finale
- ESSAIS ET DÉMARRAGE INITIAL
- LISTE DES PIÈCES
- SERVICE
OVERLAY PANELS
(CONT.)
DOOR AND DRAWER OVERLAY PANEL PREPARATION DOOR AND DRAWER OVERLAY PANEL PREPARATION (continued) (continued)
Mounting the BracketsMounting the Brackets
4) Position the brackets on each set of marks to make sure
they are aligned. (4)
Note that the support bracket mounts with its flange
toward the top of the door.
• If necessary, drill starter holes in the panel. (5)
(Use a drill stop to avoid drilling through or damaging
the finish surface.)
The installation kit includes 5/8” screws. If the panel isn’t
substantially thicker than 5/8”, you’ll need shorter screws.
1) Screw the brackets in place. (6)
Drawer PanelDrawer Panel
When preparing the Drawer Panel, follow the same
instructions as per the door panel, but make sure
measurements are taken starting from the top edge. (7)
The support bracket faces the opposite way from the door
panel bracket. (Compare images 4 and 8.)
7
8
4
5
6
© 2020 Hestan Commercial Corporation
16
EN