Use and Care Manual

SETUP INSTRUCTIONS

1) Remove station from the box and position it sink-side down on the ground so that the support

legs are accessible.

2) Find the outermost leg assembly, and pull outward from the rubber foot end. The leg assembly

will unfold until it is at a right angle to the station.

3) You will find two support struts where the leg assembly meets the table. Make sure that both

are locked completely straight to ensure the stability of the station.

4) Repeat this same process with the innermost leg assembly.

5) Once complete, flip the entire station upside down so that both sets of feet are resting on the

ground and the sink side is now facing upward.

1) Take out the whole faucet and count all components.

2) Put the faucet thread through the steel cover and rubber washer , then insert into the

hole in the table .

3) Attach the rubber washer to the faucet thread, then screw the plastic thread joints tightly.

4) Screw the pipe connection with the two black washers ( and ) to the faucet tightly.

5) Connect the water hose to the pipe connection .

Step 1: Station Setup

Step 2: Faucet Assembly

1 2 3

5 1

7 9

MULTI-USE OUTDOOR TABLE

18200

PAGE 1
8200 MULTI-USE OUTDOOR TABLE SETUP INSTRUCTIONS Step 1: Station Setup 1) Remove station from the box and position it sink-side down on the ground so that the support legs are accessible. 2) Find the outermost leg assembly, and pull outward from the rubber foot end. The leg assembly will unfold until it is at a right angle to the station. 3) You will find two support struts where the leg assembly meets the table. Make sure that both are locked completely straight to ensure the stability of the station.
PAGE 2
10 11 12 14 13 15 16 Step 3: Drainer Assembly 1) Assemble the drain pipe 16 with the thread joints 14 and washer 15 by screwing. 2) Twist the screw 10 through the steel plate 11 , large black washer 12 and the table sink hole 13 . 3) Attach the assembled drain pipe ( 14 , 15 and 16 ) to the screw 10 and twist tightly. Step 4: Cleaning and Storage Spray tabletop with water and whisk with a soft bristle brush. Disassemble the drain and remove the faucet. Allow to dry thoroughly before storage.