Use and Care Manual
5
• Mixing paddles
The quick-release chuck is fitted in the standard chuck.
3.7 Service indicator information
Status Meaning
The service indicator lights. • The carbon brushes have reached the end
of their life. The power tool will switch off
automatically after a few hours of use. Bring
the product to Hilti Service (recommended) or
replace the carbon brushes.
The service indicator blinks. • The product is faulty. Bring the product to Hilti
Service.
3.8 Items supplied
Combihammer, side handle, operating instructions.
You can find other system products approved for your product at your local Hilti Center or online at:
www.hilti.com.
4 Technical data
When powered by a generator or transformer, the generator or transformer’s power output must be at least
twice the rated input power shown on the rating plate of the power tool. The operating voltage of the
transformer or generator must always be within +5% and -15% of the rated voltage of the power tool.
The information given applies to a rated voltage of 120 V. The data may vary in the event of deviations from
the rated voltage and for country-specific versions. Please refer to the power tool’s type identification plate
for details of its voltage, frequency, current and input power ratings.
TE 50AVR
Rated power input
1,100 W
Weight (without supply cord)
13.4 lb
(6.1 kg)
Ø hammer drill bits
1/2 in … 1 1/4 in
Ø hammer drill bits
12 mm … 32 mm
Ø drill bits for wood
1/4 in … 1 3/8 in
Ø drill bits for wood
6 mm … 35 mm
Ø drill bits for metal
1/4 in … 1/2 in
Ø drill bits for metal
6 mm … 13 mm
5 Operation
5.1 Preparations at the workplace
CAUTION
Risk of injury! Inadvertent starting of the product.
▶ Unplug the supply cord before making any adjustments to the power tool or before changing
accessories.
Observe the safety instructions and warnings in this documentation and on the product.
5.1.1 Fitting the side handle 3
1. Release the side handle clamping band by turning the handle grip.
2. Slide the side handle clamping band over the chuck from the front and into the recess provided.
3. Bring the side handle into the desired position.
4. Tighten the side handle clamping band by turning the handle grip.
Printed: 30.05.2016 | Doc-Nr: PUB / 5283568 / 000 / 00