Use and Care Manual

1 Information about the documentation

1.1 About this documentation

• Read this documentation before initial operation or use. This is a is a prerequisite for safe, trouble-free

handling and use of the product.

• Observe the safety instructions and warnings in this documentation and on the product.

• Always keep the operating instructions with the product and make sure that the operating instructions

are with the product when it is given to other persons.

1.2 Explanation of signs used

1.2.1 Warnings

Warnings alert persons to hazards that occur when handling or using the product. The following signal words

are used in combination with a symbol:

DANGER! Draws attention to imminent danger that will lead to serious personal injury or fatality.

WARNING! Draws attention to a potential hazard that could lead to serious personal injury or

fatality.

CAUTION! Draws attention to a potentially dangerous situation that could lead to slight personal

injury or damage to the equipment or other property.

1.2.2 Symbols

The following symbols are used in this document:

Read the operating instructions before use.

Instructions for use and other useful information

Dealing with recyclable materials

1.2.3 Symbols on the product

The following symbols are used on the product:

Drilling with hammering action (hammer drilling)

Chiseling

Chisel positioning

Protection class II (double-insulated)

Revolutions per minute

Rated speed under no load

Diameter

1.2.4 Characters in illustrations

The illustrations in these operating instructions are intended to promote a better understanding and may

deviate from the actual version of the product.

These numbers refer to the corresponding illustrations found at the beginning of these operating

instructions.

The numbering reflects the order of the work steps in the illustration and may deviate from the

numbering of work steps in the text.

Item reference numbers are used in the overview illustration and refer to the numbers used in

the product overview section.

Printed: 30.05.2016 | Doc-Nr: PUB / 5283568 / 000 / 00