Use and Care Manual

14 English
7. Select one of the following alternatives.
▶ Use only the large flange to secure the abrasive cutting disc.
▶ Use the small flange with diamond cutting discs in order to utilize the full cutting depth.
8. Place the cutting disc with centering collar on the drive arbor and check that the direction of rotation is
correct.
◁ The direction-of-rotation arrow on the cutting disc must match the direction of rotation indicated on
the tool.
9. Place the clamping flange and washer on the drive arbor and tighten the securing screw by turning it
clockwise.
10. Insert the locking pin in the locking hole in the drive belt cover and turn the cutting disc until the locking
pin engages.
11. Securely tighten the clamping screw (tightening torque: 25 Nm).
12. Remove the locking pin.
After fitting a new cutting disc, run the tool at full speed under no load for approximately 1 minute.
5.2.2 Adjusting the guard
DANGER
Risk of injury. Flying fragments or sparks could cause injury.
▶ Adjust the guard so that flying particles or fragments of the material removed and flying sparks are
directed away from the operator and the product.
▶ Hold the guard by the grip provided and rotate it to the desired position.
Printed: 24.05.2018 | Doc-Nr: PUB / 5341998 / 000 / 02