Use and Care Manual

English 15
5.2.3 Fitting the water pump (accessory)
1. Release the three pump cover retaining screws, remove the parts and store the pump cover in a safe
place.
The pump cover must be fitted if the tool is used without the water pump.
2. Hold the water pump in position and turn the cutting disc slightly to bring the splines of water pump and
clutch bell into alignment so that the splines engage.
◁ The position is keyed so it is not possible to position the pump incorrectly.
3. Fit the three retaining screws and tighten them securely (tightening torque: 8 Nm).
4. Connect the pump hose to the hose connector on the saw.
5. Remove the protective cap from the end of the water connection hose.
6. Connect the water pump to the water supply or immerse the end of the suction hose in a container filled
with water.
The maximum permitted water supply pressure is 6 bar.
Fit the protective cap to the end of the water connection hose when the water pump is not
connected to a water supply.
5.2.4 Removing the water pump (accessory)
1. Disconnect the water supply from the water pump.
2. Fit the protective cap to the end of the water connection hose.
3. Disconnect the connector between the pump and the tool.
4. Release the three fastening screws on the pump and then remove the pump.
5. Fit the pump cover on the tool, insert the three retaining screws and tighten the screws securely
(tightening torque: 4 Nm).
Printed: 24.05.2018 | Doc-Nr: PUB / 5341998 / 000 / 02