Manualshelf

Use and Care Manual

ManualsBrandsHilti ManualsConcrete SawsDSH 600-X 12 in. Hand Held Gas Saw with 12 in. Premium Diamond Saw Blades
11121314151617181920
18 English
2. If the following equipment exists, also take this action:
DSH 600-X
▶ Press and hold down the throttle safety grip.
▶ Press and hold down the throttle trigger.
▶ Move the start/stop switch to the “start” position.
▶ Release the throttle safety grip and throttle trigger.
◁ The half-throttle position is activated.
▶ Squeeze the primer bulb 2 to 3 times to fill the primer pump bulb with fuel only when starting with the
engine cold.
▶ Check that the cutting disc is free to rotate.
▶ Place your left foot on the footplate.
▶ Pull the recoil starter pull handle slowly with your right hand until resistance is perceptible.
▶ Vigorously pull the recoil starter pull handle.
▶ Repeat this procedure until the engine fires.
▶ Briefly press the throttle trigger as soon as the engine fires.
◁ This disengages the half-throttle position and the engine will idle when the throttle trigger is
released.
6.2 Checks after starting the engine
1. Check that the cutting disc remains stationary when the engine is idling and, after briefly running at full
speed, that the disc again comes to a complete standstill.
◁ Readjust (reduce) the idling speed if the cutting disc doesn’t stop rotating when the engine is idling.
If this is not possible, please bring the product to Hilti Service.
2. Check that the start/stop switch is functioning correctly. Move the start/stop switch to the “stop” position.
3. If the following equipment exists, also take this action:
DSH 600
▶ If the engine doesn’t stop, push the choke lever upwards. If the engine still doesn’t stop, pull the
spark plug connector off the spark plug and bring the product to Hilti Service.
4. If the following equipment exists, also take this action:
DSH 600-X
▶
If the engine doesn’t stop, compress the primer bulb. If the engine still doesn’t stop, pull the spark
plug connector off the spark plug and bring the product to Hilti Service.
6.3 Switching the engine off
WARNING
Risk of injury. A rotating cutting disc can break or shatter, possibly resulting in flying fragments.
▶ Allow the rotating cutting disc to come to a complete standstill before you lay the saw down.
1. Release the throttle trigger.
2. Move the start/stop switch to the “stop” position.
◁ The engine stops.
Printed: 24.05.2018 | Doc-Nr: PUB / 5341998 / 000 / 02