Manualshelf

Use and Care Manual

ManualsBrandsHilti ManualsConcrete SawsDSH 600-X 12 in. Hand Held Gas Saw with 12 in. Premium Diamond Saw Blades
21222324252627282930
22 English
5. From below, pass the end of the cord through the hole in the starter housing and from below through the
pull handle, and securely knot the end of the cord.
6. Pull a length of the starter cord out of the housing as shown in the illustration and pass it through the slot
in the spool.
7. Hold the cord securely close to the slot in the spool and turn the spool clockwise as far as it will go.
8. Back the spool off at least ½ to max. 1½ turns, until the slot in the spool is in alignment with the opening
in the starter housing.
9. Hold the spool securely and pull the cord out of the housing toward the pull handle.
10. Hold the cord taut, release the spool and allow the starter cord to be pulled in.
11. Pull the starter cord out as far as it will go and check that the spool can be turned by hand at least a
further ½ turn clockwise. If this is not possible, spring tension must be reduced by turning the spool one
full turn counterclockwise.
12. Install the cover and secure it with the two securing screws.
13. Place the starter assembly in position and carefully press it down. Pull the starter cord slightly until the
coupling engages and the starter assembly is fully seated.
14. Secure the starter assembly with the four securing screws.
7.4 Replacing the fuel filter
When refueling the product, take care to ensure that no dirt or foreign matter finds its way into the fuel
tank.
1. Remove the cap from the fuel tank.
2. Pull the fuel filter out of the fuel tank.
3. Check the condition of the fuel filter.
◁ Replace the fuel filter if it is very dirty or clogged.
4. Slide back the clip on the hose and remove the dirty fuel filter.
5. Fit a new fuel filter and secure it with the clip on the hose.
6. Push the fuel filter back into the fuel tank.
7. Close the fuel tank.
7.5 Cleaning the spark plug, setting the spark plug gap or replacing the spark plug
CAUTION
Risk of injury. The spark plug and parts of the engine may be hot immediately after the product has been in
use.
▶ Wear protective gloves and allow the product to cool down.
Printed: 24.05.2018 | Doc-Nr: PUB / 5341998 / 000 / 02