Use and Care Manual

*2201962*

2201962 English 5

3 Description

3.1 Overview of the product 1

Chuck

;

Function selector switch

Control switch

Battery state of charge / fault display

Release buttons / battery state of charge

display

(

Battery

3.2 Intended use

The product described is a cordless (battery-powered) breaker with pneumatic hammering mechanism. The

product designed for light to medium chiseling work on masonry and surface finishing work on concrete.

▶ Use only Hilti Li-ion batteries from the B 36 series with this product.

▶ Use only the Hilti battery chargers from the C4/36 series for these batteries.

3.3 Possible misuse

• This product is not suitable for working on hazardous materials.

• This product is not suitable for working in a damp environment.

• Do not use the product where there is a risk of fire or explosion.

3.4 Lithiumion battery status display

The Li-ion battery state of charge and malfunctions of the power tool are indicated by the display on the Liion

battery. The Liion battery state of charge is displayed after pressing one of the two battery release buttons.

Status Meaning

4 LEDs light. • State of charge: 75 % to 100 %

3 LEDs light. • State of charge: 50 % to 75 %

2 LEDs light. • State of charge: 25 % to 50 %

1 LED lights. • State of charge: 10 % to 25 %

1 LED blinks. • State of charge: < 10 %

1 LED flashes, the power tool is not in working or-

der.

• The battery has overheated or is completely

discharged.

4 LEDs flash, the power tool is not in working or-

der.

• The power tool is overloaded or has overheated.

Battery state of charge cannot be displayed while the control switch is pressed and for up to 5 seconds

after releasing the control switch.

If the battery display LEDs blink, please observe the instructions given in the Troubleshooting section.

3.5 Items supplied

Breaker, side handle, operating instructions.

Other system products approved for use with this product can be found at your local Hilti Store or online at: