Manualshelf

Installation Guide

ManualsBrandsHinkley ManualsWall SconcesHinkley Lighting Axis 28" Wide Galerie Integrated LED Wall Sconce with Off White Linen Shade
123
start here
Assembly Instructions
LIGHTING
HINKLEY
English
H I N K L E Y L I G H T I N G 33000 Pin Oak Parkway Avon Lake, OH 44012 800.446.5539 / 440.653.5500 hinkleylighting.com
DRAWING 1 - ASSEMBLY
Item No: 41101,41102, 41501, 41502
1. To begin remove mounting plate (A) from
backplate(C) by removing the four screws (E)
located on the side of fixture see drawing 2.
2. Next determine which knockouts (K) need to be
removed in order to secure mounting plate (A) to
the junction box (J)
3. Use two 8-32 screws (not provided) (B) to
secure mounting plate (A) to junction box (J)
4.Next assemble finial at bottom of fixture secure
lock ups (L) on top of diffuser (D) and finial (F).
5.Connect black live wire (W) on fixture to supply
wire inside junction box (X) using wire nuts
provided
6.Connect white neutral wire (Z) on fixture to
neutral wire inside junction box (Y) using wire nuts
provided.
7.To ground fixture fasten ground wire to ground
screw inside mounting plate
8.Attach backplate (C) to mounting plate using the
four screws provided
9. Line up holes from backplate(C), shade (G), and
diffuser (D).
10. Next screw in ball knobs (H) in those holes so
that the backplate, shade and diffuser are all
assembled
For junction box mounting:
B
E
J
A
C
DRAWING 2- JUNCTION BOX MOUNTING
DRAWING 3- NON-JUNCTION BOX MOUNTING
DRAWING 4 - WIRING
X
W
Y
Z
D
E
C
E
D
F
G
□
□
L
D
F
L
E
E
A
S
U
N
For non-junction box mounting:
1.Knockout the four holes indicated on drawing 3.
2.For conduit mounting knockout ring around wire
entry (U)
3.Place the four wall anchors (N) into the wall in
a square The four wall anchors should line up with
the four knockouts.
4.Secure mounting plate by placing screws (S) in
the wall anchors.
5.Connect black supply wire (X) on fixture to
supply wire inside junction box using wire nuts
provided
6.Connect white neutral wire (Y) on fixture to
supply wire inside junction box using wire nuts
provided
7.To ground fixture wrap ground wire around
ground screw inside mounting plate
8.Attach bottom diffuser (D) using lock up (L)
9.Attach backplate (C) to mounting plate using
the four screws provided(E).
10.Line up holes from backplate(C), shade (G), and
diffuser (D).
11.
Next screw in ball knob (H) in those holes so
that the backplate, shade and diffuser are all
assembled
HH
I
I
H
I
H
I
V

Summary of content (3 pages)