Operation Manual

07-2

7.2 Service panel

Push-button Function

1 Heating system On/off switch - red LED shows function.

2 Floor heating On/off switch - red LED shows function.

(not standard equipment)

3 Light in outer tent On/off switch for light in outer tent.

4 Wall lamps On/off switch for lamps.

Holding the push-button activates the dimmer function. Light increases

and decreases.

5 Kitchen lamp On/off switch for lamp.

6 Diffused reecting lights On/off switch for lamps.

7 Ceiling lamp On/off switch for lamp.

Holding the push-button activates the dimmer function. Light increases

and decreases.

8 Indirect lighting On/off switch for indirect lighting (top).

9 Indirect lighting 2 On/off switch for indirect lighting (bottom).

10 Water tank Filling level of the water tank indicated by means of LED lights located

one above the other.

11 Main switch 1 short press of the switch

Turns off all of the appliances run by the system that are on, memori-

sing their switching status (switched on/off or dimmed). The therme and

oor heating are not switched off.

Pressing briey on the switch turns on all the lights again as memori-

sed.

If you press the switch for 5 seconds when turning everything off, all

of the 12 V appliances will be turned off, including the therme and oor

heating.

(Memory is reset.)

General note The main switch is only for the appliances controlled by the system!

All of the other appliances are not controlled or switched by the main

switch, with the exception of all 230 V appliances which are controlled

by the system (oor heating, therme) or appliances that require 12 V

control voltage (in some cases: refrigerators).