manual

The motor is in a inverted
running
The order of wiring between
motor and ESC is wrong
1. Alter any two connection line among three
connection line between ESC and motor
2. Change direction by changing the rotation
setting of motor directly with remote control or
programming panels.
The motor stops in the
flying.
The voltage of battery is lower
than default protection
threshold for low voltage, and
the protection mode for low
voltage is cut off.
1. Set the protection threshold for low voltage
correctly. Fly with battery of full voltage. The
protection mode for low voltage is set in mode of
reduces power (default mode). Please land your
model airplane in time if you find reduction of
power during the flying.
2 . Control the model airplane flying in the scope
of remote control
3 . Pay attention to the voltage of battery in
remote control. Please land the model airplane in
time if there is large reduction in voltage.
Lost of throttle signals
1. Check the operation of remote control is
correct.
2. Check if the remote control is suitable to
receiver.
3. Please try restarting to recover normal
operation if there is strong electromagnetic
interference in the operating environment. If the
problem occurs again and again, please change
flying site for there is too strong interference
from outside environment in this flying site.
Poor contact in wiring.
Check the connection between plug of battery
pack, output line of battery and connection line
of motor is reliable.