HBZ3100 HobbyZone Mini Apprentice S Manual

Mini Apprentice

Power on the transmitter. Make sure the throttle is at 0% and that throttle

trim is fully lowered on the transmitter. Power on the model. Make sure the

control surfaces (rudder, elevator and ailerons) are at neutral or 0 degrees.

Ideally, centering trim will center the surfaces. Refer to Control Centering

instructions to adjust control surfaces. Move the transmitter control sticks

so the model’s rudder, elevator and ailerons move as shown (illustrations

show a view from the rear of the aircraft). If your model does not respond

correctly, DO NOT FLY! See the Troubleshooting Guide in this manual for more

information. If you need more assistance, contact the appropriate Horizon

Product Support department.

Mode 2 is the most common control mode used worldwide. However, if you

want to change the Mode of your DXe transmitter, refer to the DXe transmitter

manual for full step-by-step instructions to achieve the desired mode change.

IMPORTANT: All trimming and Control test should be done before throttle is

advanced and in Experienced Mode.

Control Direction Test

Mode 2 Mode 1

Elevator

Ailerons

Rudder

(Perform this test in Experienced Mode)