HBZ3100 HobbyZone Mini Apprentice S Manual

®
Mini Apprentice
®
S
EN
18
Post Flight
NOTICE: When you are fi nished fl ying, never keep the aircraft in the sun. Do not
store the aircraft in a hot, enclosed area such as a car. Doing so can
damage the foam.
9
Post Flight Checklist
1. Disconnect Flight Battery
2. Power off transmitter
3. Remove fl ight battery from aircraft
4. Recharge fl ight battery
5. Repair or replace all damaged parts
6. Store fl ight battery apart from aircraft and monitor the battery
charge
7. Make note of fl ight conditions and fl ight plan results, planning for
future fl ights
Service and Repairs
NOTICE: After any impact or replacement, always ensure the receiver is
secure in the fuselage. If you replace the receiver, install the new receiver
in the same orientation and manner as the original receiver or damage
may result.
Thanks to the Z-Foam™ material in the wing and fuselage of this aircraft,
repairs to the foam can be made using virtually any adhesive (hot glue, regular
CA (cyanoacrylate adhesive), epoxy, etc). However, use only foam-compatible
CA, foam-compatible accelerant or epoxy on the vertical and horizontal
tail material.
When parts are not repairable, see the Replacement Parts List for ordering by
item number. For a listing of all replacement and optional parts, refer to the list
at the back of this manual.