HBZ3100 HobbyZone Mini Apprentice S Manual

RTF
Mini Apprentice
®
S
EN
25
Contact Information
This equipment has been tested and found to comply with the limits for
Part 15 of the FCC rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This
equipment generates uses and can radiate radio frequency energy and,
if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a partic-
ular installation. If this equipment does cause harmful interference to radio
or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one
or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment to an outlet on a circuit different from that to
which the receiver is connected.
This device complies with part 15 of the FCC rules. Operation is subject
to the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Note: Modifi cations to this product will void the user’s authority to
operate this equipment.
Antenna Separation Distance
When operating your transmitter, please be
sure to maintain a separation distance of at
least 5 cm between your body (excluding
fi ngers, hands, wrists, ankles and feet) and the
antenna to meet RF exposure safety req-
uirements as determined by FCC regulations.
This illustration show the approximate 5 cm
RF exposure area and typical hand placement
when operating your transmitter.
IC Statement:
Under Industry Canada regulations, this radio
transmitter may only operate using an antenna of a type and maximum
(or lesser) gain approved for the transmitter by Industry Canada. To reduce
potential radio interference to other users, the antenna type and its gain
should be so chosen that the equivalent isotropically radiated power
(e.i.r.p.) is not more than that necessary for successful communication.
This device complies with Industry Canada licence-exempt RSS
standard(s). Operation is subject to the following two conditions: (1) this
device may not cause interference, and (2) this device must accept any
interference, including interference that may cause undesired operation of
the device.”
Instructions for disposal of WEEE by users in the Euro-
pean Union
This product must not be disposed of with other waste.
Instead, it is the user’s responsibility to dispose of their waste
equipment by handing it over to a designated collections point
for the recycling of waste electrical and electronic equipment.
The separate collection and recycling of your waste equipment
at the time of disposal will help to conserve natural resources
and ensure that it is recycled in a manner that protects human health and
the environment. For more information about where you can drop off your
waste equipment for recycling, please contact your local city offi ce, your
household waste disposal service or where you purchased the product.
HBZ Mini Apprentice S RTF (HBZ3100)
EU Compliance Statement: Horizon Hobby, LLC hereby declares that
this product is in compliance with the essential requirements and other
relevant provisions of the R&TTE, EMC and LVD Directives.
A copy of the EU Declarations of Conformity is available online at: http://
www.horizonhobby.com/content/support-render-compliance.
FCC Information
Compliance Information for the
European Union
Country of Purchase Horizon Hobby Phone Number/Email Address Address
United States of
America
Horizon Service Center
(Repairs and Repair Requests)
servicecenter.horizonhobby.com/
RequestForm/
4105 Fieldstone Rd
Champaign, Illinois, 61822 USA
Horizon Product Support
(Product Technical Assistance)
[e-mail]
877-504-0233
Sales
[e-mail]
800-338-4639
United Kingdom
Service/Parts/Sales:
Horizon Hobby Limited
[e-mail]
Units 1–4 , Ployters Rd, Staple Tye
Harlow, Essex, CM18 7NS, United Kingdom
[phone]
Germany
Horizon Technischer Service [e-mail]
Christian-Junge-Straße 1
25337 Elmshorn, Germany
Sales: Horizon Hobby GmbH [phone]
France
Service/Parts/Sales:
Horizon Hobby SAS
[e-mail] 11 Rue Georges Charpak
77127 Lieusaint, France
[phone]