HBZ3100 HobbyZone Mini Apprentice S Manual

Mini Apprentice

Assembly

Landing Gear Installation

1. Install the main landing gear assembly (A) into the slot

on the bottom of the fuselage.

2. Place the 2 landing gear brackets (B) into location as

shown, noting the Right and Left indicators.

3. Secure the landing gear assembly into place using 4

screws (C).

4. Install the front straps (D) using the 4 screws (E) to

ensure that they do not become lost. The front straps

are required to install the Optional Float set (HBZ7390)

and Float Mounting wires (HBZ3113).

IMPORTANT: Do Not use the propeller that is included

with the ﬂ oat set.

Tail Installation

1. Install the horizontal tail (A) on the fuselage under the

linkages as shown.

2. Carefully insert the 2 pins (B) of the vertical ﬁ n (C)

through the horizontal tail holes into the fuselage

holes.

3. Under the fuselage, install the 2 screws (D) into the

fuselage and the vertical ﬁ n pins. Tighten the screws,

but do not break the plastic.

4. Connect the respective clevises in the outermost

holes in the rudder and elevator control horns. Refer

to the clevis adjustment instructions to center the

rudder and elevators.

Disassemble in reverse order.

For video assistance regarding assembly, visit

the Mini Apprentice product page at