ASSEMBLY INSTRUCTIONS TOOLS REQUIRED Allen Wrench (Included) Philips Screwdriver (Not Included) 2 - Persons Recommended ASSEMBLY RATING 000®® EASY-------1► DIFFICULT The Assembly Rating is a 5-point system showing the level of effort needed to assemble a specific product.
Thank you for your purchase! We hope you enjoy this new addition to your home for many years to come. Our commitment to providing quality products does not simply end when you purchase our product. We fully stand behind our products from start to finish. To help expedite our servi ce, please have these assembly instructions readily avai lable, along with your order receipt.
PRE ASSEMBLY INTRODUCTION We understand building ready-to-assemble furniture can be a challenging experience for some. To help avoid confusion, we have provided some helpful tips that may speed up the process. Teamwork ALWAYS have at least two people to help with transporting and assembling the product to avoid potential injury and/or damage. Suitable Location Assembling near the area of the intended location is highly recommended.
ASSEMBLY AND CARE ADVICE � FAILURE TO FOLLOW THE GUIDELINES BELOW MAY A) RESULT IN INJURY AND/OR PROPERT Y DAMAGE. Position each part correctly and insert screws or bolts into their respective holes. Turn clockwise to tighten and only tighten when step is completed or when instructed to do so. Use the appropriate hand tools or power tools for assembly. Select steps, such as tightening screws and/or bolts, may require hand tools to avoid causing damage during assembly.
x4
ASSEMBLY INSTRUCTIONS 1 Part@)x 1 pc Part@)x 1 pc Part@x 1 pc Hardware @x I. 11. 2 pcs Align the front leg support (#4) with the pre-drilled holes of the left front leg (#1) and the right front leg (#2). Insert 2 bolts (#A) through the left front leg (#1) and the right front leg (#2) using the Allen wrench (#C) to secure them with the front leg support (#4). Note: Right and left are determined by facing the front of the chair in the upright position. #1 2 Part@)x lPC Hardware I. 11.
ASSEMBLY INSTRUCTIONS 3 Part@x 1 pc Hardware @x 4 pcs I. II. 4 Align the seat (#5) with the pre-drilled holes on the left front leg (#1) and the right front leg (#2). Secure 4 screws (#B) through bottom of the left front leg (#1) and the right front leg (#2) using the Phillips screwdriver to secure them with the seat (#5). ., l\ I', ��'�.., 'i \' I \' I ' I I I l 'I 1 ' , I #3 Make sure the chairs are rested on a flat surface and do not feel loose or wobbly.
