Instruction Manual

White Wire Trigger:

If you are using the White wire (points or electronic amplier) of the HyperSpark 2 to trigger the ignition, follow these

steps:

1. Make sure the ignition switch is in the OFF position.

2. Remove the coil wire from the distributor cap and position the terminal so it is approximately 1/2” from a good

ground.

3. Disconnect the HyperSpark 2 White wire from the distributor points or the ignition amplier.

4. Turn the ignition to the ON position. DO NOT CRANK THE ENGINE.

5. Tap the White wire to ground several times. Each time the wire is pulled away from ground a spark should jump from

the coil wire to ground. If spark is present, the ignition is working properly.

Ignition Testers, PN 8998 or PN 89981, are available for troubleshooting. This tool allows you to check your complete

ignition system while it is in the car as well as the operation of RPM limits, activated switches, and shift lights.

Technical Support: 1-866-464-6553

Date: 02/03/23

FRM36389