Manual

1
Section 1. Unpacking and Installation
Unpacking
Before unpacking your Doran scale, please read the instructions in this
section. Your new scale is a durable industrial product, but it is also a
sensitive weighing instrument. Normal care should be taken when
handling and using this product. Improper handling or abuse can
damage the scale and result in costly repairs that may not be covered
by the warranty. If you notice any shipping damage, notify the shipper
immediately. Please observe the following precautions to insure years
of trouble free service from your new scale.
! DO NOT drop the scale.
! DO NOT drop objects on the scale.
Carefully remove the scale from the shipping carton. Be sure to retain
all shipping materials in case the scale must be shipped elsewhere.
Installation
Place the scale on a stable flat surface. Verify that the bubble level
located under the platter shows that the scale is level. Adjust the four
feet to obtain a level condition (bubble in center.)
Electrical Connections
The DS100 uses a wall mounted transformer to provide power to the
scale. The transformer requires 115 VAC, 50/60 Hz power. Be sure the
AC power is not excessively noisy – this can occur if large inductive
loads, such as solenoids or motors, are on the same power line.
Subjecting electronics to problematic AC power lines may result in
damage not covered by the warranty. Also be sure that the power outlet
and transformer are not exposed to water while the scale is plugged in.
Care & Cleaning
With reasonable care, this product will last for many years. Here are
some tips to care for your DS100 Scale Indicator.
• Hand clean with a damp cloth using mild detergent.
• Do not use strong solvents or abrasive cleaners as this can damage
the touch panel or other plastic parts.
• Do not drop or overload the scale.
• Do not use sharp objects to press any of the buttons.
• Do not immerse.