User Manual

C HAPTER 1:INTRODUCTION
3
DISPLAY
Display types differ according to model. The table below describes the
display(s) offered for each controller.
Table 1: 60 Series Displays
Model Display
460, 465, 560
660
6 digit, Vacuum Florescent display (VFD)
0.75” (19mm) height with 2X5 matrix
661 4-line by 20-character alphanumeric VF display
(8mm)
562, 662 240 x 64 backlit LCD graphic, 3 font sizes
663 Available in two versions:
• 6 digit, Vacuum Florescent display (VFD) and
4x20 character alphanumeric VF display
OR
• 240x128 backlit LCD display
665 Available in two versions:
• 6 digit, Vacuum Florescent display (VFD) and
4x20 character alphanumeric VF display
OR
• 240x128 backlit LCD display
The vacuum fluorescent (VF) display is divided into two sections: a large,
six-digit numeric area to the left, and a smaller, two-line-by-five-character
dot matrix area to the right.
The large digit area displays numeric data, such as Gross Weight, Net
Weight or Tare Weight. The dot matrix area has several purposes:
• The first two characters on the upper line show the weighing units of the
displayed data.
• The last three characters on the upper line show a CENTER ZERO (--
>0< --) condition at times.
• The lower line of the dot matrix area specifies the type of data, such as
Gross, Net, Tare, etc.
The dot matrix area also displays specific messages during controller
operation and setup.