User Manual

C HAPTER 6:ADDITIONAL O PERATING M ODES
41
CHECK WEIGH ABSOLUTE AND PERCENTAGE
OPERATION
The standard check-weigh operation is designed to check the weight of an
item against a given standard or target weight. In the check weigh absolute
mode, values are entered as target limits. In the check weigh percent mode,
the values are entered based on percentage.
SET THE HI AND LO WEIGHTS (460)
1. Press [SELECT] until prompt = “mName SETUP”.
2. Press [TARE] prompt =”10.00 High” (by default)
3. Use the [PRINT] key to enter a number ( [UNITS] key moves
placeholder over 1 spot)
4. Press [TARE] prompt = “5.00 Lo”.
5. Repeat steps 2 – 4 to enter in low value
6. Press [TARE] indicator returns to previous display mode.
USE CHECK WEIGH (460)
1. Press [SELECT] until prompt = “mName START”
2. Press [ENTER]. The display will return to the weigh mode.
3. To stop check-weighing, press [SELECT] until prompt = gross mode.
Note: if your weight is greater than your hi weight then the prompt = “OVER” is
displayed. If your weight is less than your Lo weight the prompt = “UNDER” is
displayed. If your weight is between the Hi and Lo then prompt = “GOOD” is
displayed.
SET THE HI AND LO WEIGHTS (465,560,562 AND 660 SERIES)
1. Press [TARGET] or [F2] prompt = “10.00 Hi”. (by default)
2. Key in the desired high value weight.
3. Press [ENTER] prompt = “5.00 Lo”. (by default)
4. Key in the low value weight.
5. Press [ENTER] indicator returns to previous display mode.
USE CHECK WEIGH
1. Press [F1] to start check-weighing
2. Add your weight to the scale.
3. Press [TARGET] or [F2] key to stop check-weighing