Instructions

SAFETY
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at 14
LK 4ESZ
12 SAFETY
12.1 Intended Use
The machine must only be used for its intended purpose! Any other use is deemed to be a case of
misuse.
To use the machine properly you must also observe and follow all safety regulations, the assembly
instructions, operating and maintenance instructions lay down in this manual.
All people who use and service the machine have to be acquainted with this manual and must be
informed about the machine's potential hazards.
It is also imperative to observe the accident prevention regulations in force in your area.
The same applies for the general rules of occupational health and safety.
The machine is used for:
Lifting and moving of fixed loads.
Any manipulation of the machine or its parts is a misuse, in this case HOLZMANN-
MASCHINEN and its sales partners cannot be made liable for ANY direct or indirect damage.
W A RNI NG
 The motor of the machine is protected with a thermal fuse. When the thermal fuse
responses, the machine stops. The machine can be used again only after cooled
down (app. 5 minutes).
 The machine is suitable for operating mode S3 (25% operating time: 2,5 min at
10 min) and not for continuous operation.
Ambient conditions:
The machine may be operated:
humidity
max. 70%
temperature
+5°С to +40°С
The machine shall not be operated in areas exposed to increased fire or explosion hazard.
Prohibited use:
 The operation of the machine outside the stated technical limits described in this manual is
forbidden.
 The operation of the machine without provided protective devices is prohibited
 The use of the machine not according with the required dimensions is forbidden.
 Any manipulation of the machine and parts is forbidden.
 The use of the machine for any purposes other than described in this user-manual is forbidden.
 The unattended operation on the machine during the working process is forbidden!
 It is explicitly prohibited that persons stayed or walked under or in the immediate vicinity of the
suspended load!
 To lift loads connected to earth is forbidden!
 Swinging with the hung load is forbidden!
 Lifting of loads hung outside of axis of gravity is forbidden!
 To lift people or animals is explicitly forbidden!
W A RNU NG
Never exceed the maximum payload. When lifting and transporting the center of gravity should
be in the same area with "I" steel beams. Otherwise the machine must not be operated. If the
construction is abnormal during lifting and transport stop the operation immediately and
eliminate the problem. "I" steel which is deformed, bent or cracked, does not conform to the
standard, or has other defects, must not be used as a track of the machine.