Instructions

OPERATION
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at 17
LK 4ESZ
14 OPERATION
Machine to be operated in a perfect state only. Inspect the device visually every time it is to be
used. Check in particular the safety equipment, electrical controls, electric cables and screwed
connection for damage and if tightened properly. Replace any damaged parts before operating
the device.
14.1 Operation instructions
W A RNI NG
Perform all machine settings with the machine being disconnected
from the power supply!
NO TIC E
 In addition to these operating instructions also read the operating instructions of
the hoists used! (Pulley block or electric cable pull)
 Inspect the machine visually before each use.
 It is to check the end stops are present so that the machine can not crash
 Before using the machine, ensure that there are no contamination contours or
obstacles on the carrier and along the track
 In particular, check the perfect state of the snap hooks preventing any
unintentional release of the lifting hook from slings (ropes, rings, transportation
eyes, etc.).
 All lifting work is only allowed when appropriate fixing elements (ropes, rings,
transport loops, etc.) are used and when in accordance with appropriate
provisions and standards valid in the workplace.
 The machine can only be used for lifting of loads whose weight does not exceed
the maximum payload specified by the producer in technical data and on the
type label of the machine.
 Attach the load correctly.
 Lifted loads may only be lifted in a vertical position! Never pull and lift in an
inclined position!
14.2 Operation
 Check, whether the emergency switch (10) is pressed. For unlocking, turn the emergency
switch clockwise.
 For moving the machine, press the left/right switch (9).
 In the emergency case press the emergency switch immediately. The machine stops.