Instructions / Assembly

PLEASE RETAIN THIS INFORMATION FOR YOUR FUTURE REFERENCE
OPERATING INSTRUCTION:
⚫ Insert (3) AA batteries, sold separately, into battery compartment on back of unit.
⚫ Press the ON/OFF button to light up LED. Press it again to turn it off.
⚫ The TRY-ME feature is intended for in-store demonstration only.
Please remove TRY-ME wire and insert batteries into battery compartment during normal operation.
⚫ Remove battery if the product is to be left unused for a long period of time.
BATTERY INSTALLATION:
⚫ Locate battery compartment on back of unit.
⚫ Remove compartment door using a small Phillips-head screwdriver, sold separately.
⚫ Place (3) new AA batteries, sold separately, into the compartment, matching the polarity of the batteries to the markings
in the compartment.
⚫ Replace battery compartment door and hand tighten screw to hold door in place.
TIMER
This item contains a timer. When the button is switched to the ON position, the item will light up and glow for 6 hours, then
automatically go off. The next day it will come on at the same time. It is 6 hours on and 18 hours off. Cancel the timer by switching
the button to the OFF position until LED lights turn off.
CAUTION:
⚫ Do not mix alkaline, standard (carbon-zinc) or rechargeable (nickel-cadmium, ni-mh etc.) batteries.
⚫ Do not mix old and new batteries. Replace all batteries of a set at the same time.
⚫ Clean both ends of the battery contacts and the contacts of the device prior to installing the batteries.
⚫ Ensure the batteries are installed correctly with regard to polarity (+ and -).
⚫ Remove batteries from equipment that is not to be used for an extended period of time.
⚫ Remove used batteries promptly.
⚫ Batteries should only be changed under adult supervision.
⚫ Do not dispose of batteries in fire. Batteries may explode or leak.
⚫ Exhausted batteries are to be removed from the product.
⚫ Batteries are harmful if swallowed. Keep away from young children.
Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s
authority to operate the equipment.
Notes: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged
to try to correct the interference by one or more of the following measures:
⚫ Reorient or relocate the receiving antenna.
⚫ Increase the separation between the equipment and receiver.
⚫ Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
⚫ Consult the dealer or an experienced radio/TV technician for help.