Instructions / Assembly

7.1 7. 2 8.1
Be sure nothing is
blocking the sensor.
Cable pairs are
color-coded to insure
proper color-matching
connections.
Your Howling Werewolf with LifeEyes is now fully assembled. Plug in and turn on
to let the fun begin
Secure the Sensor and the (K)
Costume with the hook and loop
closures as shown
IR SENSOR
3/3
Sensor / Détecteur
5.9 V
Try Me / Essaie-moi / Pruébame
OPERATION INSTRUCTIONS:
1. Plug the AC adapter into a standard power outlet and adjust the settings on the Function Control Box, located on the
(I) Function Control Box Frame.
2. Settings:
Sensor - This switch mode will activate lights, sound, and animation when the Infra-red (IR) sensor is activated and will operate
for 1 audio-cycle with each activation. The Infra-red (IR) sensor has a range of up to 2 m/6.5 ft. and will activate when
someone comes within an 80-degree angle from left-to-right, as well as from above and below.
(OFF/TRY ME) – This switch mode either turns off the item OR allows the item to be activated only if triggered by using a Step
Here Activation Pad or Try Me Button (not included). The item will operate for one audio cycle with each Try Me
activation.
I (ON)
- This switch mode will continually operate the lights, sound, and animation of the item.
- Raise or lower the volume using the volume control turn dial, turn all the way down to turn the volume off .
This device complies with Part 15 of the FCC Rules . Operation is subject to the following two conditions:(1) This device may not cause harmful interfer-
ence, and (2) this device must accept any interference received, including interference that may cause undesired operation.
CAUTION: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the
equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures: Reorient or relocate the receiving antenna, Increase the separation between the equipment and receiver, Connect the
equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or experienced radio/TV technician for help.
Distributed by Home Depot
2455 Paces Ferry Road Atlanta, GA 30339
1-877-527-0313
CAN ICES-3 (B)/NMB-3 (B)
Sensor / Détecteur
5.9 V
Try Me / Essaie-moi / Pruébame
L
Q