SDS

TMMQ/GPTD-PS/A00
GUANGZHOU TIANQIU ENTERPRISE CO., LTD
We reserve all ri
g
hts for the chan
g
e of product specification and an
y
information without an
y
prior notice.
6 / 7
7． Caution for Use
1) Since the battery is not designed to be charged, there are risks of electrolyte leakage or
causing damage to the device if the battery is charged.
2) The battery shall be installed with its “+” and “-” polarity in correct position, otherwise may
cause the battery to be charged or over-discharged.
3) Short-circuiting, heating, disposing of in fire and disassembling the battery are prohibited.
4) Battery cannot be forced discharge, which lead to excess internal gas generation and, may
result in bulging, leakage and explosion.
5) New and used batteries cannot be mix used at the same time, when replaced batteries, it is
recommend to replace all and with the same brand type.
6) Exhausted batteries should be removed from compartment to prevent over-discharge, which
cause leakage and damage to the device.
7) Direct soldering is not allowed, which will damage the battery.
8) Keep the battery out of the reach of children to prevent swallow, in case of accident should
contact physician at once.
9) The battery should not be dismantled and deformed.
caution：
 If a battery is leakage and materials contact eyes, flush immediately with running water for at
least 15 minutes. Consult an ophthalmologist at once.
 If battery emits an odor, fever, discoloration, deformation or any abnormal phenomena appeared
in the process of use/storage, removed the battery immediately from the device and dispose of
the battery.
8．
Referenced Standards
IEC 60086-1:2011 Primary Batteries –Part 1: General
IEC 60086-2:2011 Primary Batteries –Part 2: Physical and electrical specifications
IEC 60086-4:2007
Primary Batteries –Part 4: Safety of lithium batteries