Use and Care Manual
For technical support and assistance, call 844-894-6659
19
8. Replace the lter, skimmer basket and weir.
9. Check for leaks inside the spa cabinet, especially at the plumbing unions near pump(s) and heater. Hand tighten unions if
necessary. If the spa is leaking and the unions are tight do not turn the GFCI on. Call a technical service associate at 844-894-6659
for assistance and repair before applying power to the spa.
10. If there are no visible leaks inside the cabinet, turn the GFCI “on”
11. When power is applied to the spa, the spa controls will immediately begin a self check cycle, which can take up to 30 minutes.
Do not touch the buttons on your topside controls until the prompt appears on the topside display!
The model specic topside control instructions will help you determine when it is safe to begin setting your preferences. Make sure
water is circulating through all jets, that the air controls, diverter and waterfall valves are functioning properly. If the spa is functioning
properly and there are no leaks inside the spa cabinet, reinstall the cabinet access panel.
There’s a ne line between too much water and not enough. If the water level is too low, air is sucked into the plumbing lines which
causes serious damage to the spa. If the water level is too high, lighting and audio components become submerged causing them to fail
prematurely. So how do you know when enough is actually enough?
It’s important to pay attention to the water level as bathers enter and exit the spa. The number of gallons displaced by one person is
lower than the number of gallons displaced by six people and the number of gallons displaced by six children who weigh 50 pounds is
lower than the number of gallons displaced by six adults who weigh 150 pounds. What may be the perfect water level for six children
may cause the spa to overow with six adults, but six children might splash out more water than six adults displace. You should expect
to add or remove water depending upon use. Every time you exit the spa, check the water level and add water if necessary.
The water level will vary depending upon the spa model you purchased. As a general rule, when the spa is empty the water level should
be at least 4 inches over the lter basket and below the perimeter lighting and audio components.
Re-Filling your Spa with Water
Follow these step by step instructions every time you re-ll the spa to ensure successful start up. If you need to replace the screws on
the cabinet, use stainless steel screws which do not rust.
THE WATER LEVEL
Filling your Spa with Water