Use and Care Manual
For technical support and assistance, call 844-894-6659
23
Pre-Programmed Factory Settings
Your spa will start in Ready Mode
The temperature is pre-programmed to 100º F
The Duel Temperatures are pre-programmed to a minimum of 80º F and a maximum of 104º F
The ltration cycle is pre-programmed to run once each day for 2 hours
Initial Temperature Display
After briey displaying the pre-programmed temperature setting, this message will be displayed on your topside controls. The water
must circulate through the heater chamber for approximately one minute before the current water temperature can be displayed
on the topside controls. When the water temperature reaches the pre-programmed temperature setting, the pump will turn o
automatically. To display the current pre-programmed temperature setting, press the “Temp” button once. The current water
temperature will ash on the display.
When the display is ashing, the spa controls are in programming mode. To prevent accidently changing pre-programmed settings, after
you press a button, you should wait 5 seconds before pressing a dierent button.
Turning the Jets On and Off
Pump 1 is a two speed pump. Press the “Pump 1” button to operate pump 1 on LOW SPEED. Press the “Pump 1” button
a second time to operate on HIGH SPEED. Press the “Pump 1” button a third time to turn it o. If the “Pump 1” button is
not pressed to turn it o manually, it will shut sown automatically after 20 minutes. To turn it back on, press the “Pump 1”
button and repeat the process. The Ozonator engages when pump 1 is operating on LOW SPEED.
Pump 2 is a single pump. Press the “Pump 2” button to turn it on. Press the “Pump 2” button a second time to turn it o.
If the “Pump 2” button is not pressed to turn it o manually, it will shut down automatically after 20 minutes. Press the
“Pump 2” button to turn the pump back on.
In spas equipped with 3 pumps, pump 3 is a single speed pump. Press the “Pump 3” button to turn it on . Press the
“Pump 3” button a second time to turn it o. If the “Pump 3” button is not pressed to turn it o manually, it will shut down
automatically after 20 minutes. Press the “Pump 3” button to turn it back on.