Use and Care Manual

For technical support and assistance, call 844-894-6659
24
To ensure your safety and for optimal performance, your spa controls will automatically perform maintenance functions and run diagnostic
testing. The pump will start automatically on low speed to circulate the water for a few minutes every hour to run a system check. During heating,
ltration and diagnostic testing the pump runs on low speed. When the pump starts automatically and operates on low speed to perform these
maintenance functions, pressing the pump button will not turn the pump o.
When a button is pressed to turn a pump on, a clean up cycle will begin 30 minutes after the pump shuts down. The pump will operate on LOW
SPEED and the ozonator will engage. Both the pump and ozonator will operate for approximately 30 minutes to help eliminate dirt, bacteria and
other particulates as soon as they are introduced to the water
Turning the Lights On and Off
Press the “Light” button once to turn the lights on. The colored light will rotate. Press the “Light” button to turn the light o.
To display only one color, press the “Light” button repeatedly turning the lights on and o. When the color your desire turns
on do not turn the light o. Press the button only when ready to turn the light o. If the “Light” button is not pressed to turn
the lights o manually, the lights will turn o automatically after 2 hours. Press the “Light” button to turn the lights back on.
If your spa is equipped with optional perimeter lighting, the perimeter lighting feature work in tandem with the main light.
Operating the Audio Components
Press the “Stereo” button to turn the built in audio components on. Press the “Stereo” button a second time to turn
them o. If the button is not pressed to manually power o the audio components, they will power o automatically after
2 hours. Press the “Stereo” button to turn it back on. Music from your Mp3 player will play through the built in audio
components when your the device is plugged into the audio jack. The Mp3 Cargo Bay is built into the spa cabinet on
the same side as the topside controls. Use your Mp3 player to select music and to control the volume. If the model you
purchased is equipped with Bluetooth capability, open the Bluetooth settings on your Mp3 player and connect it to the spa
to stream your music wirelessly. Enter “0000” if a pairing code is required.
For your safety and to protect your device, your Mp3 player should always be stored in the Mp3 Cargo Bay. When you remove your Mp3
player from the Cargo Bay, always press the “Stereo” button to turn the speakers o. Leaving the audio components on causes overheating
that will permanently damage the audio components. Damage to the audio components that occurs because the components were not
turned o is not covered under the warranty.
Mp3 Audio Jack