Use and Care Manual

For technical support and assistance, call 844-894-6659
25
Changing the Programmed Settings and Operating Modes
Press the “Temp” button once to enter programming mode.
When the display on the topside control is ashing, the spa is in programming mode.
In most cases, pressing the light button saves the change.
To prevent accidentally changing programmed settings, after pressing one button wait 5 seconds before pressing a dierent button.
Adjusting the Programmed Water Temperature Setting
To change to programmed temperature settings, press and release the “Temp” button. The display on the topside controls will
ash, indicating you have entered programming mode. While the display is still ashing, press and hold the “Temp” button it
until the desired temperature is reached. To move the temperature in the opposite direction, continue holding the button. The
temperature will automatically begin moving in the opposite direction when the maximum temperature is reached. Release the
“Temp” button when the desired temperature is displayed on the topside controls. Press the light button to save the change
and exit programming mode. If the programmed temperature is increased, pump 1 will turn on automatically to begin heating
the water.
Dual Temperature Ranges
When you are setting Duel Temperature Ranges, pay attention to the direction of the arrow displayed on the topside controls.
The spa controls allow you program two temperature range settings with independent temperature settings that are most commonly
used to program a “Ready to Use” setting and a “Vacation” setting. When a range is chosen, the spa will heat to the temperature
settings associated with that range. For example, the high range might the set with a low temperature of 80º F and a high temperature
of 104º F and the low range might be set between 60º F and 99º F. Freeze protection is active in either range.
To program the rst temperature range, press the “Temp” button. While the display is ashing, press the “Light” button. “TEMP” will be
displayed on the controls. If the arrow beside the word “RANGE” is pointing up, program the HIGH temperature setting. If the arrow is
pointing down, program the LOW temperature. Press and hold the “Temp” button until the desired temperature is reached. Press the
“Light” button to save the change. Repeat the process to program the opposite temperature range. If necessary, press the “Temp”
button to change the direction of the arrow. Press and hold the “Temp” button until the desired temperature is reached. Press the
“Light button to save the changes.