Use and Care Manual

For technical support and assistance, call 844-894-6659
27
Freeze Protection
If the water temperature falls to 42º F, the spa will automatically turn on and will run for 4 minutes after the water temperature reaches
46º F to prevent freezing. If your spa is in Sleep Mode when the ambient temperature is 40º F or lower, the water temperature will
likely operate in Freeze Protection Mode for extended periods if not continuously.
Show and Set the Time-of-Day
Setting the time of day is important for determining when ltration cycles and other functions will performed. If no time of day is set,
“SET TIME” will ash on the display if no time-of-day is stored in the memory. When the power supply to the spa is interrupted, the
time will not be saved. If ltration cycles must be run at a particular time resetting the time-of-day will be required. When the GFCI
is powered on, the default time-of-day is 12:00 Noon. Though “SET TIME” will still ash on the display, if the GFCI is powered on at
Noon, the ltration cycle will run at Noon.
To set the time of day, press the “Temp” button. While the display is ashing, repeatedly press the “Light”
button until “TIME” appears on the topside display. To set the HOUR, press and hold the “Temp” button until
the correct hour is displayed. Press the “Light” button to save the hour and begin setting the MINUTES. Press
and hold the “Temp” button until the correct time is displayed. Press the “Light” button to save your selection.
Flip the Display
The message on the topside display can be inverted for easy reading both inside and outside the spa.
To invert the display, press the “Temp” button once. When the display is ashing, press the light button
repeatedly until the word “FLIP” ashes on the topside controls. Press the “Temp” button to invert the display.
“FLIP” will begin ashing in the inverted direction. Press the “Light” button to save the change.